|
||||
The Transair engineered piping system is a cost-effective way to install an efficient and attractive piping system. The smooth-bore pipe keeps fluid friction to a minimum and imposes a very low pressure drop. The pipe is available in aluminum for air, vacuum and inert gases, and stainless steel for water. The aluminum pipe is available in powder coat finishes for easy identification. The Transair piping system is completely mechanical. No flame is required for assembly so it’s ideal for sensitive areas.
One of the biggest advantages to the Transair system is how easy it is to modify to fit changing needs in your plant.
For compressed air, inert gases and vacuum, Transair aluminum piping is offered in diameters of 16.5mm (1/2”), 25mm (1”), 40mm (1½”), 63mm (2½”), 76mm (3”) and 100mm (4”). All sizes are available in blue and grey for easy identification. The 25mm and 40mm sizes are also available in green.
The 16.5, 25 and 40mm Transair fittings use “push to connect” technology – push the pipe into the fitting and the joint is complete. The joints can easily be disassembled and the pipe and fittings are reuseable.
The larger sizes of Transair use different locking mechanisms, but the result is the same – an easily assembled joint that can be easily disassembled and re-used.
View Transair Piping for Air & Inert Gas Catalog
The Transair system has a maximum working pressure of 188 PSI at temperatures up to 140°F. At temperatures of 115°F and below the maximum working pressure is 232 PSI. For vacuum service, Transair can be used down to 29.6” Hg. at temperatures up to 140°F.
This is a completely pre-engineered system. Pipe, valves, fittings, hangers and outlets all fit together easily to save you time and money.
Transair offers a line of 304 Stainless Steel piping for use with liquids. The primary application of this piping is for industrial water with additives. It is offered in sizes of 22mm (3/4”), 28mm (1”), 42mm (1½”), 60mm (2¼)”, 76mm (3”) and 100mm (4”).
This fully mechanical system allows for joints to be easily disassembled and re-used as needed, making maintenance and modification of industrial water systems much easier to perform. This system is rated for pressures up to 145 PSI and operating temperatures from –4°F to +185°F for the ¾ and 1” sizes and up to 140°F for the larger sizes.
The ¾ and 1” sizes use push-to connect fittings. The larger sizes use different locking mechanisms.
The Transair system makes using stainless steel easy and economical!
View Transair Stainless Steel Piping for Water Catalog
